Re: Reading the data from ADXL362 with MSP430G2230
One more quick example for you. Again, not specifically for the MSP430, but offer another example of a C-code that manages the interface with the ADXL362, this time for a FPGA....
View ArticleRe: ADAU1961 Linux kernel for 3.2.26
Hi Lars, Thanks for the reply. The adau17x1 branch unfortunately is based on the 3.10+ kernel. I am using the 3.2.26 kernel. My kernel already has support for the adau1373 and adau1701. This is...
View ArticleRe: ADAU1961 Linux kernel for 3.2.26
Hi, No, the adau1373 and adau1701 are completely different compared to the adau1761/adau1961. - Lars
View ArticleRe: setting for ADV7511 ARC(audio return channel)
Hi Mike, Thank you for all the information. I've looked through ADV7511_API_Library, it only has the interface for CEC, but no underlying implement for ADV7511. From link...
View ArticleAD8138
Hi there,I am using AD8138 to make differential input for my ADC which does not have a S&H. The problem I have is the two differential signals are not balanced! Although the output of the AD8138 is...
View ArticleRe: ADAU1772 linux driver
Hi Pavel,Usually, one of us will notice that a post would get more attention if it is in a different forum and move it. I was away last week, so Yagami got to you first. Thanks, Yagami! I see you added...
View Articlecan't enable ADV7511 CEC interrupt
Hi, I'm trying to implement CEC function by myself, based on "ADV7511_Programming_Guide" Rev G. Here is my setting for CEC:1. enable CEC power & clock/timing2. enable CEC Tx & Rx interrupt3....
View ArticleRe: ADAU145x missing in Tree ToolBox - SigmaStudio
It is important to remember that the ADAU1452 can selfboot from an EEPROM, alleviating the need for a micro on the board. It has the capability also of acting as a boot 'agent' for other parts on the...
View ArticleRe: ADAU1772 SPI Boot from uC
I will move this discussion to the Blackfin community to see if it can get answered! Regards,Coleman
View ArticleRe: ADAU1761 single write/read question
Thanks for the heads up about the ADAU1761 datasheet, Yagami. We will get that fixed! Regards,Coleman
View ArticleRe: ADV7842 CEA 1280x720 30hz Detection
Hi Matthew, 720p/30 is a very unusual format, many TVs do not support nor do most of our receivers. ADV7842 does support it I believe but there may be something unusual you have to do for it. I'll...
View ArticleEVAL-AD9833 board
Hello, I have a Eval-AD9833SDZ board and also EVAL-SDP-CB1Z board to communicate with ad9833. But I need an information that how much lowest frequency I can get from AD9833 board by using EVAL-SDP-CB1Z...
View ArticleRe: ADV7280-M Driver
Hello, I'll check on the status of the Linux driver. I don't believe there is an Android driver or any plans to create one (at least by ADI). Dave
View ArticleRe: Regarding simultaenous operation mode of ADV7604
Hi Ronak, ADV7842 can do a +5V detect but ADV7604 you have to do it externally. What you are planning is probably the best way to do it for ADV7604. Dave
View ArticleRe: Pin state in Reset active for ADAU1442 and ADAU1452
Hi Takepiro-san, I have information regarding the ADAU1442. In reset mode: All LRCLK, BCLK and SDATA_IN pins are inputs, and each has an internal pullup of approximately 80 k ohms.All SDATA_OUT pins...
View ArticleRe: Using ADV7619 (or other HDMI Rx) as an HDMI 'tester'
Hi Paul, ADV7619 is already used in HDMI test equipment-- but for the protocol analysis. I don't think it's really useful for analog testing as you propose. I don't think you would have enough...
View ArticleRe: ADV7611 disordered when input signal unstable
Hello, I'm not sure what you are seeing-- certainly disconnection is going to unlock the PLL but it will relock when the signal comes back. Glitching on the TMDS signals could also cause problems....
View Article