Hi Di,
At long last, I got past the error listed above. It turns out that the super classes you guys are using for the Simulink blocks only work with 2013b or greater (which I had my license updaded to in order to run).
Alas, another error occured once I got that set-up (and, yet again, I was hoping you could provide some insight into this one). I followed the instructions on the Wiki for set-up, including installing the windows x64 driver, building the Libiio library on the Zync, and entering the correct IP from the Zync. However, when attempting to run either the iio_source_sim.slx or iio_sink_sim.slx I am hit with the following error:
Any ideas? I am going to ask MATLAB Central if nothing else.
Thanks again for all your assistance!
Will