Clik here to view.
Re: Readback gain reduction of Dynamic Processor with ADAU1452
Hello Bernd and Miguel, SteveL came up with an ingenious way to produce a true exponential decay for a level meter. By applying feedback to a External Decay Peak Detector, he sets up the...
View ArticleRe: AD-FMCOMMS5 with KC705
There are no problems. The AD9361 part of the no-OS is independent of any carrier or FPGA (it is all through the SPI). At present, we don't have a reference design on KC705. If you have successfully...
View ArticleRe: Sine wave in No-os driver FMcomms1-ebz
Yes-- by programming the corresponding registers. Go through the user doc. and try to understand the design and the user controls.
View ArticleRe: Using no OS driver with custom h/w in verilog
I suggest you try a simple (such as the "hello word") EDK tutorial using Vivado (IPI) and SDK first.After the basic concepts are clear, you can take on FMCOMMS1.
View ArticleClik here to view.
Re: Precision of the state-variable filters
Looks like I answered my own question. It's well known that fixed-point IIR filters have the most difficulty when set for a low frequency (f << fs), and high Q. Thus I made a test of 2nd...
View ArticleCommunication with camera via PPI - different VSYNC signalization
Hi I am working with BF526 EZLITE. I am trying to capture image from OV7670 using PPI in 2 external frame syncs mode.All the time I have 2 faults in PPI status register - Horizontal Tracking Underflow...
View ArticleRe: Why PAL Video work good but RGsB Video does not?
I was checked output voltage and it is bigger than video standard voltage but it did not have problem so I did not want to small it. Figure 5 ?what is the meaning of TNT?
View ArticleClik here to view.
Re: Sine wave in No-os driver FMcomms1-ebz
Where will I find its user doc ? is this ithttp://www.analog.com/static/imported-files/overviews/FMC-Communications_Product_Highlight.pdf
View ArticleRe: VGA and Audio Extraction from HDMI input signals
Then, what is the purpose of HDCP adopter?Please explain briefly.
View ArticleClik here to view.
Re: ADuCM361 ADC drift at increasing ambient temperatures
Thanks for reproducing the test. Can you confirm that this is with 75k between AIN0 and AIN1? Our results are very different from yours:
View ArticleRe: ADV7280 HSYNC and VSYNC Polarity
Hi Nicholas,Apologies you are correct. Different bits are needed to invert the synchronization pins (HS, VS, etc) when the deinterlacer (I2P core) is enabled.The bits to invert the synchronization pins...
View ArticleRe: ADV7611 - BT656 10 Bit YCbCr 4:2:2 output
The ADV7611 data sheet does not indicate it can do 10-bit SDR BT.656. However the ADV7612 can. See Table 78, OP_FORMAT_SEL=0x01 The ADV7611/12 can not convert any format to 720x576. To do format...
View ArticleRe: Why PAL Video work good but RGsB Video does not?
TNT should have been TFT, (typo) ADV7125 data sheet Figure 5
View ArticleRe: VGA and Audio Extraction from HDMI input signals
1) Use HDCP logo2) Be able to purchase HDMI keyed receivers. No vendor will sell you keyed receivers unless you are an HDCP adopter.
View ArticleRe: [ADV7614] How to disable CSC?
I think you are looking for DPP_BYPASS EN, CP 0xBD[4]. Check out the Pass through mode section in the hardware manual What input and output color spaces do you want?
View Articlehittite hmc 624alp4e issue
hi everyoneabout the hmc624alp4e if I use serial control interface for hmc624alp4e, is it ok to left floating all parallel ports which is from D0 to D5(Port 19 to 24) and PUP1(Port 17) and PUP2(Port...
View ArticleRe: ADuM3223/4223 Fundamental Questions on operations
Hello Usaghi, Q1) VDD2 is shorthand for EITHER (VDDA to GNDA) or (VDDB to GNDB). The UVLO for each channel block works independently, so if VDDA to GNDA falls below the UVLO level, but VDDB to GNDB...
View ArticleClik here to view.
ADR421 long term drift graph data
I did not see the graph of long term voltage output drift in the datasheet for the ADR421. Is this something you can provide ? Thanks.
View ArticleRe: Very low sensitive of AD9874
Moved this question on the AD9874 to the High-Speed ADC community.
View ArticleRe: AD9361 RX EVM vs. Interferer Power
Hi Tlili, Could you please let us know the transmitter EVM for the Rx EVM tests done. We are not able to produce the results as provided by the data sheet. We are using a FMCOMMS-2 board and analysis...
View Article