Hi Karen,
Thanks a lot for your time and help. Originally I tried software Ver. 1.70 from the disk with the AD7626 eval board. After the GUI reported this error, I searched on-line and our forum and found the original Labview programme which is Ver. 1.65 giving the same response. I have followed your suggestions and tried again. The following are the snapshots of software and hardware configurations. Where Figure 3 verifies the device driver was successfully installed according to the Eval-AD9625/26EDZ user manual. Figures 4 and 5 give the hardware status after configurations through PulSAR CED Rev 1.7.
Kind Regards,
Shaodong
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5