Hi Adam,
My questions was to understand your setup, hence the reason I mentioned stepping back in my reply to you.
You said that the earlier suggestions of the (Feb 4, 2015, 12:00PM) removed the dark areas, but resulted in the output becoming over bright?
Could you tell us the values in the following registers:
/* CP_CONTRAST: CP Map, 0x3A[7:0]
/* CP_SATURATION: CP Map, 0x3B[7:0]
/* CP_BRIGHTNESS: CP Map, 0x3C[7:0]
/* CP Map, 0x3E[7:0].
/* CP Map, 0x40[7:0].
Could you try the following settings below:
/* set DPP_BYPASS_EN = 1 at CP Map, 0xBD[4] // this action bypasses the DPP & CSC block
/* set RGB__OUT = 1
/* set OP_656_RANGE = 0
/* set AGC_MODE_MAN = 1
/* set GAIN_MAN = 1
/* set the clamp_enable bit at CP map, 0x6C[4] = 1
Regards,
Edwin