Hello ADI support:
I am using the AD9434 ADC in a chemistry measurement system. The AD9434 output is LVDS into Altera FPGA, but FPGA side is non-terminated (See Schematic Page 13 below).
SiTime Oscillator SiT9107AC-23FH33E500.000000 drives AD9513, strapped for 1:1 for driving AD9434 Clock. (Page 9)
These lines 100 ohm differential pairs are terminated on-board in 100 ohms (See Page 25)
We have tested the output for fixed pattern transmission by setting Test_IO Reg 0Dh Bits7 & 6 (with fixed patterns loaded into Registers 19h,1Ah, 1Bh, 1Ch) and have no errors receiving
USER_PATT1_LSB,USER_PATT1_MSB
USER_PATT2_LSB, USER_PATT2_MSB
When we clear the bits in Test_IO Reg 0Dh for analog ADC output, we get this pattern with a DC voltage in or a sinusoidal input:
Page13:
Page 9:
Page 25:
Can you help me resolve this issue?
Let me know if you require more info.
Thank you