Load Pull Measurement system utilize our Zed board + AD-FMCOMMS1-EBZ FMC

Hi FPGA Reference Designs Team,

Currently I plan to develop Load Pull Measurement System using Envelope Load Pull Technique. Now I having these equipment or measurement tools:

1. 1- Zed board + AD-FMCOMMS1-EBZ FMC
2. 2- Anritsu Power Meter
3. 3- N9030A PXA Signal Analyser
4. 4- N512B Vector Signal Analyser
5. 5- Bridge Coupler
6. 6- Power amplifier

Based on these equipment, I am going to setup Load Pull Measurement System as shown in Figure below.

This system will utilize Zed board + AD-FMCOMMS1-EBZ FMC as Envelop Load Pull Module (ELP) as shown in following figure.

From this measurement system, my outcome is to determine a new load reflection coefficient by manipulating value I and Q baseband signal.  

I’m new in RF field. My questions are

1. Can I can plot smith chart from this I and Q  from ADC/Demodulator without Vector Network Analyser (VNA)?
2. What is the maximum power dbm accepted by Zed board + AD-FMCOMMS1-EBZ if I add power amplifier on the system.
3. Should I fix travelling wave, b2 match to carrier frequency of AD-FMCOMMS1-EBZ to 2.4Ghz only?

Best Regards,