Hi Ian,
Thank you for responding so quickly.
I downloaded the two softwares from analog.com last week, the version numbers are:
Visual Analog: 1.9.45.52
SPI Controller: 4.0.7.4062
The driver located properly under the Analog Devices tab in the Device Manager ( HADv6-FMC ver 2.1.2.0)
The .mcs file is ad9625fmc_evalez_20140820_1331.mcs
The cal file loaded by theSPI controller is AD9625C_12Bit_2.5GSspiR03
Other than programming the board using Visual Analog, the only instruction I am using is in the SPI Controller, to change the JESD204x 'Serial Quick Configuration' (in theADCBase1 tab) to "Generic 8 Lane Config" as I am using 2.0 or 2.5 GSps sampling rate. I found this is Rev0.2 of theAD9625 EV Board Quick Start Guide. Is there a newer version of this Guide, or any more complete documentation of the EV Board and EVALEZ Board for this device?
Thanks,
John
