Hi Jonathan,
I've checked the device manager and it shows as following.
ADI Development Tools
Analog Devices System Demonstration Platform SDP-B
So I think it's been installed correctly.
I tried to check the supply voltages but the ground pins and the supply voltages for digital and analog circuits are beside each other and there was a risk of short-circuiting during the measurement so it was difficult to make the measurements. It would be helpful to have the layout diagram to know where to prove.
What I observe is that the Labview program does record samples except it does not do it continuously. I am guessing that the problem might lies in the controller or the program.
Thank you,
Isaac