Hi,
Thank you very much for your reply, and sorry to take time but we have additional questions.
In regard to (4), what is the best way how do we setup to shutdown the internal video processing ?
We can see two power-down modes descried in UG-180, as Power-Down Mode 0 and Power-Down Mode 1, however both mode seems to disable audio blocks.
So, do we need to set other registers in order to shut down only at video output block ?
If you instruct more practical description how to do this, it would be very much appreciated.
(5) UG-180 shows four crystal frequency selection and 28.63636 MHz is set as default.
(5-a) Do we need any specific care when using other than 28.63636MHz ?
(5-b) When using ADV7611 as the way described in above (4), does crystal input still need to be provided ?
Even if it is briefly, your instruction how this crystal is used for internal processing, it would be very much appreciated.
Best Regards,